![]() ![]() ![]() If the number is set too low, printing time could be shortened as the building plate doesn’t have to wait as long for the resin to stabilize in the resin vat. If the number is set too high, printing time may take longer as the building plate has to wait for resin to stabilize in the resin vat. This refers to the time the building plate lifts, retracts, and then waits while printing 3D models. ![]() If you set the number too low, prints may fall off easily during the printing process. If you set the value too high, your print may stick tightly onto the building plate, making it harder to remove. If the number is set too low, your prints may not be fully cured. If the number is set too high, your prints may over cure, thus losing details. If there are an insufficient amount of bottom layers, models may not attach to the building plate in a stable manner. Setting an excessive amount of bottom layers will serve as a stabilizing base but will increase printing time. If the number is set too low, your model may take longer to print, but there will be finer details. If the number is set too high, your model will print faster, but details of the model may be lost. If the number is set too low, the Z-axis will move slowly, increasing printing time, but your models will have a higher chance of being printed successfully.ĬHITUBOX Slicing Software Parameters Layer Height If the number is set too high, the Z-axis will move fast, reducing the printing time but your models may become damaged in the process. This refers to the speed at which the Z-axis moves during printing. If the number is set too low, printing time could be shorter as the building plate doesn’t have to wait as long for resin to stabilize in the resin vat. This refers to the delay time needed for when the building plate lowers and waits for the UV lights to light up. This refers to the amount of time required for the bottom layer to cure. This refers to the amount of time required for each layer to cure. This refers to the number of bottom layers you have set. Special Note: Kickstarter recently disabled remote embedding for images on project pages, so embedding code doesn't work on project pages (yet) - just everywhere else.Phrozen OS Web Interface Parameters Layer Thickness ![]() Here are a few quick snippits of code you can use to embed your personalized widget on your website, in your blog, and even on your favorite forum.īBCode for forums Copy BBCode Help your backers reach your daily goals and help others see how you're doing. ![]()
0 Comments
Leave a Reply. |